Configuring Static Routes with ip commands

As a system administrator, you can configure static routes using the ip route command.

To display the IP routing table, use the ip route command. For example:

~]$ ip route
default via 192.168.122.1 dev ens9  proto static  metric 1024
192.168.122.0/24 dev ens9  proto kernel  scope link  src 192.168.122.107
192.168.122.0/24 dev enp1s0  proto kernel  scope link  src 192.168.122.126

The ip route commands take the following form:

ip route [ add | del | change | append | replace ] destination-address

See the ip-route(8) man page for more details on the options and formats. 

 

To add a static route to a host address, in other words to a single IP address:

~]# ip route add 192.0.2.1 via 10.0.0.1 [dev interface]

where 192.0.2.1 is the IP address of the host in dotted decimal notation, 10.0.0.1 is the next hop address and interface is the exit interface leading to the next hop. 

 

To add a static route to a network, in other words to an IP address representing a range of IP addresses:

~]# ip route add 192.0.2.0/24 via 10.0.0.1 [dev interface]

where 192.0.2.0 is the IP address of the destination network in dotted decimal notation and /24 is the network prefix. The network prefix is the number of enabled bits in the subnet mask. This format of network address slash network prefix length is sometimes referred to as classless inter-domain routing (CIDR) notation.

To remove the assigned static route:

~]# ip route del 192.0.2.1